Christie Digital Systems / Roadster / Removing Lamp

Christie Digital Systems / Roadster / Removing Lamp

Removing the lamp for Roadster projector.

1. TURN THE LAMP OFF 
Press (power) to turn the lamp off. Allow the cooling fans to stop automatically (within approximately five minutes) before proceeding with Step 2.
This wait period is also required to allow the lamp to sufficiently cool before handling. 

2. UNPLUG THE PROJECTOR
When the cooling fans have stopped, turn the projector’s main switch off, and unplug.

3. OPEN THE LAMP DOOR
Using a #2 Phillips screwdriver, loosen the ¼-turn lock screws (2) securing thelamp door, which is located at the rear of the projector below the input panel.

4. REMOVE LAMP RETAINING BAR
Remove the two (2) screws that secure the retaining bar along the bottom edge of the lamp module using a #2 Phillips screwdriver.

5. REMOVE THE LAMP MODULE
Firmly grasp the handle and pull the lamp module straight out of the projector. 

    • Related Articles

    • Christie Digital Systems / Boxer / HDMI Input Fault

      Related Products: Christie Boxer 2k30 Description: Christie Boxer which shows problems with the HDMI input on the HBMIC card Log Error: "Option Card 1 Initialization Fault (SYST:054)" Resolution: 1. Check Card is Seated 2. Upgrade Projector firmware ...

    • Christie Digital Systems / Boxer / Interrogator file

      interrogator file for boxer Running the Boxer interrogator The interrogator captures diagnostic information Christie personnel uses to help diagnose and correct any issues. 1. Insert a USB flash drive in the USB port on Boxer 2K. If two USB flash ...

    • Christie Digital Systems / M & J series / Updating the projector.

      Updating the M & J series projector. Upgrade can be done through the web interface. 1. Login to webpage.  2. Go to Admin Page.  3. Activate upgrade mode.  Note: Projector must be in standby.  4. Click on Upgrade. Wait for UI to change.  5. Select ...

    • Christie Digital Systems / 4K10-HS / Out of focus

      We've received your report regarding the projector (4K10-HS) having some issues with the focus. Christie 4k10-HS Lens: 0.85-1.02:1 Confirm if the lens calibration has been done before using the projector and lens cap has been removed from the lens ...

    • Christie Digital Systems / Microtiles / Screen Maintenance

      The first step to be able to service this display will be to identify any the issues with the video wall. To do this, we will need to review the Status export from the Master ECU and note any physical issues with the hardware. From the status export, ...